» » » » WLL 1500 kg Hinged Vertical Plate Clamp CX jaw 20-40mm

WLL 1500 kg Hinged Vertical Plate Clamp CX jaw 20-40mm

395.00 € Excluding VAT

REFERENCE -EU-HVC-1500CX-L
Available Product available

Hinged Vertical Plate Clamp CX, multi-position, WLL 1500 kg, jaw opening 20-40 mm
For vertical lifting sheet metal adopted in all positions

Quantity : 
+
-
Add to quotation requests

hinged vertical plate clamp cx 1500 kg opening 20-40mm
See larger image

Product Descriptions
Specifications
safety instructions
Notice

This plate clamp CX with hinged hook rings, WLL 1500 kg, with bigger jaw opening of 20-40mmcan be used for the safe handling of plate at various angles. It can lift plate from the horizontal and put down in the vertical. The hinged hook ring ensures an adequate gripping pressure in every position.

 

The plate clamp CX shares all the benefits of the CY clamps, but are specifically designed for heavier duty applications up to 10,000kg.

The other benefit that the CX clamps offer over the CY clamps is that vertically racked plates can be turned through 90 degrees

 

Hardness of plate surface must below HRC 30/Brinell 300.

Back to top
Product Descriptions
Specifications
safety instructions
Notice

Mini lifting capacity: 225 kg

Opening: 20-40 mm
Weight: 7 kg

   A : 160

   B : 399
 C : 63
 D : 48
 E : 70
 F : 83

Back to top
Product Descriptions
Specifications
safety instructions
Notice

The correct way to a safe use :

  • Always use 2 clamps and a beam.
  • Plate must be at full depth and lever locked into place.
  • Chipped teeth are only allowed if the clamp teeth are undamaged
  • Never lift plate unless fully engaged to the rear of the clamps
  • Only lift 1 plate at a time,
  • A spreader beam should be used for long plates
  • Never use endless chain slings
  • Check positioning of the clamp prior to use, a wrongly positioned clamp will reposition itself when it reaches the top dead centre and can release the plate
  • There should be enough slack in the chain sling to permit the lever to fully operate
  • Never force the chain lug if stuck, tap gently
  • Any force will possibly cause the camshaft to fail
  • You must not rapidly lower the load to the ground as the crane hook will force the clamp open and release the plate
  • Never lower unless the lever is in the locked position 
Back to top
Product Descriptions
Specifications
safety instructions
Notice

Reviews about this WLL 1500 kg Hinged Vertical Plate Clamp CX jaw 20-40mm (0 reviews)

pixel_trans
There is no review for this item, add the first one.
pixel_trans
pixel_trans
[Add your review]
Back to top
In the same category
Products viewed
< >
Back to top
In the same category
Products viewed
< >
Back to top
The administrator of the site is online now! Talk - ask your questions to webmaster