» » » » 500 kg Vertical Lifting Clamp autolock jaw 0-16 mm

500 kg Vertical Lifting Clamp autolock jaw 0-16 mm

190.00 € Excluding VAT

REFERENCE -EU-VLC-500VA
Available Product available

Lifting Plate Clamp capacity 500 KG,
Jaw opening 0-16 mm, equipped with auto-lock,
Lift plate from horizontal to vertical & vice versa

Quantity : 
+
-
Add to quotation requests

universal clamp metal sheet - wll 500 kg
See larger image

Product Descriptions
safety instructions
Notice

Vertical Lifting Plate Clamp, capacity of 500 kg, Jaw opening 0-16 mm, equipped with a Reverse manual safety Lock, Used on all hot rolled structural steel plates and sections up to a surface hardness of 300 Brinell/32 Rockwell C, the clamp can be used to lift plate from the horizontal to vertical position and vice versa through 180 degrees, high hardness steel jaws for optimal pinching spring safety lock pressed on the jaw, which prevents the opening of the clamp, even when there is no load in the jaw, equipped with hold-open and lock-closed device
The standard clamp is fitted with a hook ring, the Clamp jaw and pads are manufactured from high tensile steel and have heat treated serrated teeth
Use 2 clamps with a lifting beam 

 
Mini lifting capacity : 50 kg 
jaw opening : 0-16 mm 
Weight : 1,500 kg

 D : 0-16 mm Opening Max/Min

A : 66 mm

  B : 195 mm
C : 29 mm
          E : 47 mm maxi
 F : 50 mm

 
Back to top
Product Descriptions
safety instructions
Notice

The correct way to a safe use :

  • Always use 2 clamps and a beam.
  • Plate must be at full depth and lever locked into place.
  • Chipped teeth are only allowed if the clamp teeth are undamaged
  • Never lift plate unless fully engaged to the rear of the clamps
  • Only lift 1 plate at a time,
  • A spreader beam should be used for long plates
  • Never use endless chain slings
  • Check positioning of the clamp prior to use, a wrongly positioned clamp will reposition itself when it reaches the top dead centre and can release the plate
  • There should be enough slack in the chain sling to permit the lever to fully operate
  • Never force the chain lug if stuck, tap gently
  • Any force will possibly cause the camshaft to fail
  • You must not rapidly lower the load to the ground as the crane hook will force the clamp open and release the plate
  • Never lower unless the lever is in the locked position 
Back to top
Product Descriptions
safety instructions
Notice

Reviews about this 500 kg Vertical Lifting Clamp autolock jaw 0-16 mm (0 reviews)

pixel_trans
There is no review for this item, add the first one.
pixel_trans
pixel_trans
[Add your review]
Back to top
In the same category
Products viewed
< >
Back to top
In the same category
Products viewed
< >
Back to top
The administrator of the site is online now! Talk - ask your questions to webmaster